User Guide

ManualsBrandsLincoln Electric ManualsOtherIM586-B

B-1

OPERATION

B-1

Setting the DIP Switch

The DIP switch is labeled with an “ON” arrow showing

the on direction for each of the 8 individual switches in

the DIP switch (S1). The functions of the switch are

also labeled and set as described below:

Wire Drive Head Selection

The STT-10 control is set up for proper presettable

wire feed speed by setting S1 DIP switches (1 and 2)

as appropriate per the following examples for the head

specification and 10 Series wire drive external gear

selection being used:

For K1563-1,-3 or K1568-Series (10 Series Boom) or

K1560-1,-2 (10 Series Bench) with 35-500 IPM (0.89-

12.7 m/m) Low Speed Ratio

set S1 DIP Switch as fol-

lows: (initial factory setting)

For K679-1 (Synergic 7F Boom) with 50-770 IPM

(1.27-19.5 m/m) Low Speed Ratio

set S1 DIP Switch

as follows:

For K679-2 (Synergic 7F Boom) with 80-1200 IPM

(2.00-30.5 m/m) High Speed Ratio

set S1 DIP Switch

as follows:

Metric/English Wire Feed Speed Display

Selection

The STT-10 Control is set up for Wire Feed Speed dis-

play in Metric units (m/min.) or English units (IPM) by

setting S1 DIP Switch 4 (Labeled “M”):

S1 switch 4 OFF = IPM (as shipped)

S1 switch 4 ON = m/min

STT-10

OPERATING INSTRUCTIONS

Safety Precautions

Duty Cycle

The STT-10 models are rated at 60% duty cycle *

for a

maximum current of 600 amps.

* Based on a 10 minute time period (6 minutes on, and 4 minutes off).

STT-10 CONTROL DIP SWITCH

SETUP

Initial set up of the STT-10 control for the system

components being used and for general operator

preferences is done using an 8-pole DIP switch locat-

ed inside the STT-10 control box.

Setup DIP Switch Access

1) Shut off the input power to the STT-10 control by

turning off the power at the welding power source

it is connected to.

2) Remove the two screws on the top of the STT-10

control box door and swing the door down to

open.

3) Locate the 8-pole DIP switch, near the top left cor-

ner of the STT-10 Control P.C. board, labeled S1.

NOTE: Switch settings are only programmed during

input power-up restoration.

ELECTRIC SHOCK can kill.

• Do not touch electrically live parts such

as output terminals or internal wiring.

• Unless using cold feed feature

when inch-

ing with gun trigger, electrode and drive mech-

anism are “hot” to work and ground and could

remain energized several seconds after the

gun trigger is released.

• Turn OFF input power at welding power

source before Control switch setup or

changing drive roll and/or guide tubes.

• Welding power source must be connected

to system ground per the National

Electrical Code or any applicable local

codes.

• Only qualified personnel should

operate this Equipment.

WARNING

Observe all additional Safety Guidelines detailed

throughout this manual.

Head

M 4

S R

12 3456 78

Head

M 4

S R

12 3456 78

Head

M 4

S R

12 3456 78

Head

M 4

S R

12 3456 78

Head

M 4

S R

12 3456 78

Head

M 4

S R

12 3456 78