User Manual

A-8
INSTALLATION
LN-10 / ZIPLINE BOOM PACKAGE
A-8
INSTALL THE CONDUIT BUSHINGS and
ELECTRODE CONDUIT
With the provided 1/8” allen wrench, remove the
incoming guide on the wire drive assembly. Two dif-
ferent size conduit bushings are provided in the con-
duit bushing kit, .025 to .063 and .063 to .125. Based
on the wire used for your application, find two appro-
priate wire size conduit bushings. Install one of the
conduit bushings where the incoming guide was.
Install the second conduit bushing in the clamp on the
conduit bushing bracket, located on the boom mast
above the spindle mounting bracket. Install the elec-
trode conduit between the two conduit bushings.
Push the electrode conduit into the bushing until it
stops. Screw the knurled knob assembly into each
conduit bushing to securely hold the electrode conduit
in place. Neatly place the conduit in the trough. Re-
install the trough cover.
INSTALL THE 2” SPINDLE ASSEMBLY
With a 3/4” wrench, install the 2” spindle assembly
using the 1/2-13 x 3.00 bolt and washers provided.
Place the larger washer into the spindle assembly
before installation to the boom mast spindle bracket.
Line up the small hole on the spindle assembly with
the roll pin on the mast. After the 2” spindle assembly
is in place, completely tighten the bolt.
INSTALL THE GUN CONTROL PLUG
CABLE ASSEMBLY and
THE GUN AND CABLE ASSEMBLY
Install the provided gun control plug cable assembly to
the front of the wire drive assembly. Install the gun
and cable assembly per the instruction manual provid-
ed with the gun. Gun adapters may be required if
using a Non-Lincoln gun.
INSTALL THE WELDING POWER SOURCE
Install the welding power source per the instruction
manual provided with the power source.
INSTALL THE WIRE REEL, DRIVE ROLLS
AND GUIDES
Load the wire reel with a coil of wire so as to dereel off
the side of the coil closest to the conduit bushing.
Install the appropriate drive rolls and guides for your
specific wire size application per the instruction manu-
al provided with the wire feeder. Thread the wire
through the entire length of conduit to the drive rolls to
feed through the gun cable. Repeat this step for the
opposite side of your wire feeder.