Owner manual

A-6
INSTALLATION
POWER WAVE
®
455M/STT
®
A-6
CONFIGURING THE SYSTEM
For codes below 11100, consult the semi-automatic
Power Feed
®
instruction manual for configuration
information about DIP switch settings.
For codes above 11100, the power source will “Auto
Map” the system eliminating most of the need to set
DIP switches to configure the system.
If a system can not be “Auto Mapped” then the status
light on the power source will blink green fast and the
welder output will be disabled. If a system is not
“Auto-mappable”, then consult the instruction manual
for the accessory being used for configuration infor-
mation about DIP switch settings, or consult your local
Lincoln sales representative.
POWER WAVE
POWER WAVE
455M/STT
455M/STT
®
®
POWER W
POWER WA
VE
VE
455M/STT
455M/STT
®
®
POWER W
POWER WA
VE
VE
455M/STT
455M/STT
®
®
POWER W
POWER WA
VE 455M/STT
VE 455M/STT
WIRE
WIRE
DRIVE
DRIVE
MODULE
MODULE
ROBOT
ROBOT
PLC Controller
PLC Controller
analog Interface
analog Interface
etc.
etc.
TYPICAL
TYPICAL
/HARD
/HARD
AUT
AUT
OMA
OMA
TION
TION
(using Wire Drive Module and PF10R
(using Wire Drive Module and PF10R
PF10R
PF10R
®
®
SINGLE HEAD FEEDER
SINGLE HEAD BOOM FEEDER
DUAL HEAD FEEDER
Up to 4 Feeders
Allowed
Up to 4 Feed
Heads Allowed
FH 1
Dual Head