Instruction Manual

Chapter 11. Weld Listing Tab Profile Reports
11.12 CheckPoint™ User Manual IM8000
Criteria on the Profile Reports
You can customize this graph to show the data on the report for all Weld Profiles or for a specific profile (as
long as they are trained), as well as for different time durations. See Table 11.5 for details on the criteria
available.
Figure 11.7 Criteria for the Profile Reports
Table 11.5 Criteria Available on the Profile Reports
Field Description
Start Date and
End Date
Select a date range in which the weld(s) were performed for the profile data you want
to review. Welds completed within this date range (that also occurred during the shift
you select) appear in the resulting report.
TIP | You can type the date into the field, or you can click the calendar icon ( )
next to the field to display an interactive calendar where you can click on the date
you want. Use the arrow icons ( and ) to navigate to previous or future months.
The double arrow icons ( and ) move forward and backward by three-month
intervals.
Shift If you want to see WeldScore™ data for profiles used during a specific shift over the
date range you chose, select that shift from the Shift drop-down. CheckPoint™
narrows the data to include only welds performed during the times of that shift. The
CheckPoint™ administrator configured the shifts in the CheckPoint™ Manager.
Group By The Group By drop-down allows you to set the report to display data by year, months,
days, hours or shifts.
For example, if you select Hour from the Group By drop-down and the Shift you select
is for a single eight-hour shift, the graph will show data for each individual eight hours.
Weld Profile You can generate the report for a specific Weld Profile used for the welds performed
during the date range selected. Simply type the number of the one specific profile or
type the word “All” to see data for all profiles. Remember, the Weld Profile must have
limits enabled in order for CheckPoint™ to display any data.