Instruction Manual

Update the Welding Power Source Firmware Chapter 2. Preparing for CheckPoint™
IM8000 CheckPoint™ User Manual 2.3
Procedure Details
update.
You can enter the IP address for the Welding
Power Source in one of two ways:
 Type the specific IP address into the I
know the IP address of the welder field.
 Choosing the I do not know the IP
address of the welder option. The
update utility scans your network and
displays a list of Welding Power Source
IP addresses on the same subnet.
NOTE | If this Welding Power Source has
older firmware, the IP address will not show up
using this method.
TIP | If you run into a problem, please refer to
the Troubleshooting section (0).
7. Click the Connect button once you have
entered the IP address for the power source
you are updating.
The software scans the Welding Power Source to
verify if the firmware currently on the machine
is up to date.
TIP | You can also see this information under
System Status > Module Information > Software
Version in Power Wave® Manager. See Error!
Reference source not found. on page Error!
Bookmark not defined..