Instruction Manual

Navigating CheckPoint™ Chapter 6. Overview
IM8000 CheckPoint™ User Manual 6.3
Individual Reports
The heart of CheckPoint™ is the individual reports you have available under each Report Tab. CheckPoint™
collects welding data from each weld produced by each Welding Power Source that your administrator
connected to the system. Depending if you have a single Welding Power Source selected or a Container of
power sources selected, the data displayed on the report is a little different.
Figure 6.4 Example Weld Listing Reports
For example, if you select a single Welding Power Source, the reports on the Weld Listing tab relate
specifically to that power source. However, if you select a Container of power sources, the reports on the
Weld Listing tab relate to all the power sources in that Container. You will also find that there are a few
individual reports or widgets that only apply to a single Welding Power Source and are not available for a
Container (and vice versa).
NOTE | In-depth information on the reports begins with Chapter 7.
Panel Resize
To the right of the Asset Tree and under the Individual Reports are the Panel Resize bars (Figure 6.1 on page
6.1). When you click and drag the bar with your mouse, you can increase or decrease the size of the areas
on either side of the bar.