User Manual

D-3
D-3
MAINTENANCE
GUN HANDLE DISASSEMBLY
The internal parts of the gun handle may be
inspected or serviced if necessary.
The gun handle consists of two halves that are
held together with a collar on each end. To
open up the handle, turn the collars approxi-
mately 60 degrees counterclockwise (the same
direction as removing a right hand thread) until
the collar reaches a stop. Then pull the collar
off the gun handle. If the collars are difficult to
turn, position the gun handle against a corner,
place a screwdriver against the tab on the col-
lar and give the screwdriver a sharp blow to
turn the collar past an internal locking rib.
Counterclockwise
„
English Metric
Description Part No. Size Size
CABLE LINER
For 15' (4.5 m) or KP42-25-15 .025" – .030" 0.6 – 0.8 mm
shorter Cable KP42-4045-15 .035" – .045" 0.9 – 1.1 mm
KP42-4045-15 3/64" 1.2 mm
(Alum. wire) (Alum. wire)
CONTACT TIPS
Standard Duty KP2744-025 .025" 0.6 mm
KP2744-030 .030" 0.8 mm
KP2744-035 .035" 0.9 mm
KP2744-045 .045" 1.1 mm
Tapered KP2744-030T .030" 0.8 mm
KP2744-035T .035" 0.9 mm
KP2744-045T .045" 1.1 mm
Tab (For Aluminum) KP2744-364A 3/64" 1.2 mm
(Alum. Wire) (Alum. Wire)
GAS NOZZLES
Fixed (Flush) KP2742-1-38F 3/8" 9.5 mm
KP2742-1-50F* 1/2" 12.7 mm
KP2742-1-62F 5/8" 15.9 mm
Fixed (Recessed) KP2742-1-38R 3/8" 9.5 mm
KP2742-1-50R
1/2" 12.7 mm
KP2742-1-62R 5/8" 15.9 mm
Requires: Gas
Diffuser As'bly KP2746 * .025" – .045" 0.6 – 1.1 mm
Insulator KP2773-2 *
GUN TUBE ASSEMBLIES
Standard (60°) KP3078-60 *
45° KP3078-45 *
TABLE D.2
ACCESSORIES AND EXPENDABLE REPLACEMENT PARTS
FOR MAGNUM PRO 250L GUN AND CABLE ASSEMBLIES
* Included with POWER MIG® 216
** Tapered tips are required with 3/8” I.D. and 1/2” I.D. Nozzles.
See www.lincolnelectric.com for complete offering of Magnum Pro consumables.
POWER MIG® 216