Manual


"#%'"!

*%%*%& "&
"!'%"&!&''!&
'56@:.056;25.@A523<99<D6;40<;A?<9@
&2264B?2
#"*%&*' – Turns power on and off to the
machine.
% )"' "!'%" J This knob sets the
output voltage of the machine. Along with wire feed
speed (WFS) this control sets a weld procedure.
Refer to the procedure decal on the inside wire
drive compartment door to set a correct welding
procedure based on type of material and thickness
being welded.
*%&#"!'%"*&JThe knob
sets the speed that the machine feeds wire. Along
with arc voltage this control sets a weld procedure.
Refer to the procedure decal on the inside wire
drive compartment door to set a correct welding
procedure based on type of material and thickness
being welded.
&2264B?2
(! '%% J Depress the trigger to activates
the wire drive to feed wire and energizes the output
of the machine. Depress the trigger to weld and
release the trigger to stop welding.
*! (! J Delivers wire and welding cur-
rent to the weld.
a. Gun Liner – wire travels through the liner from
the wire drive. The gun liner will feed .025 to .035
wire. The 180A machine can weld with .045 wire
if an optional .045 liner is installed in the gun.
b. Contact Tip – provides electrical contact to the
wire.
c. Nozzle – When flux-cored welding the black noz-
zle protects the mounting threads on the gun.
When MIG welding the brass nozzle funnels the
shielding gas to the weld.
*"%  #   J Clamps to the work
piece being welded and completes the electrical
welding circuit.
(! '%% "!!'"% %#' J
Plug the 4 pin gun trigger connector into this recep-
tacle.
11
33
22
(% 
(% 
4
5a
5b
5
5c
6
7
.035"(0.9mm)
NR-211-MP
WIRE SPOOL
"#%'"%O&N !(