Use and Care Manual

NOTE: Installation of the M21182 harness and spool gun selector switch is

not required for all machines. If a spool gun switch is pre-installed in the

machineʼs wire drive compartment, then the SPOOL GUN / WIRE DRIVE

SLECTOR SWITCH INSTALLATION SECTION can be disregarded.

INSTALLATION

SPOOL GUN / WIRE DRIVE

SELECTOR SWITCH

INSTALLATION

. Install the M21182 electrical adapter

harness that came with the spool gun

per the following instructions.

ELECTRIC SHOCK CAN KILL.

2. Disconnect input

power from the

machine.

------------------------------------------------

OPEN THE MACHINE

3. Remove two 5/16“ hex hinge screws

from door.

4. Remove ten 5/16“ hex screws from

cover.

5. Remove screws from cover.

(A) is the location of two 3/4” long

screws.

6. Remove cover.

7. If machine has a plastic handle (A),

then remove screw (B).

WARNING

A-6