DESIGNER IM649 User guide

A.4 PULSE WAVE DESIGN PROCESS
The Wave Designer software interfaces with the welding machine controller to permit real time
communication of pulse wave design changes. Refer to paragraph 2.3 for equipment interface
connections.
Use the following wave design process to customize a standard wave shape. The process is
summarized in the following flowchart. The flowchart is followed by a detailed process
description. To ensure that the design process creates a wave shape suitable for your weld
application, we recommend that you perform all editing functions in the order presented. Where
an editing function is described as optional and you choose not to perform the edit function,
proceed to the next edit function in the design process.
FIGURE A-4. PROCESS FLOWCHART.
Appendix A A-5
PULSE WAVE SHAPING PRINCIPLES
WAVE DESIGNER
27850021
Set NO-ADAPT
Set ADAPT
Save File to Disk; Develop Next Workpoint
A-4.2 Step 1
A-4.1
A-4.2 Step 2
A-4.2 Steps 3 & 4
A-4.2 Steps 5, 6, & 7
A-4.2 Step 8
Section 3, paragraph 3.4
Select a Waveform
from Memory
Mode = OFF
Select Workpoint
Set Powerwave WFS
Set Trim = 1.00
Set Arc Control = OFF
Adjust Pulse
Variables at
Fixed Stickout
Adjust Peak Volts
and
Adaptive Type
Adjust Optional
Variables
(if needed)
Save File to Disk
GO FIGURE
GO FIGURE
Download File to Welding
Machine Memory
PROCESS FLOW: REFERENCE
PARAGRAPH:
(SEE APPENDIX A)