DESIGNER IM649 User guide

B.4 STT WAVE DESIGN PROCESS
The Wave Designer software interfaces with the welding machine controller to permit real time
communication of STT wave design changes. Refer to paragraph 2.3 for equipment interface
connections.
Use the wave design process to customize a standard wave shape. The process is summarized
in Figure B-4. The flowchart is followed by a detailed process description. To ensure that the
process creates a wave shape suitable for your weld application, we recommend that you
perform all editing functions in the order presented. Where an editing function is described as
optional and you choose not to perform the edit function, proceed to the next edit function in the
design process.
FIGURE B-4. PROCESS FLOWCHART.
B-6 Appendix B
STT WAVE SHAPING PRINCIPLES
WAVE DESIGNER
27850061
Save File to Disk; Develop Next Workpoint
B-4.2 Step 1
B-4.1
B-4.2 Step 2
B-4.2 Step 3
B-4.2 Step 4
Section 3, paragraph 3.4
Select a Waveform
from Memory
Mode = OFF
Select Workpoint
Set Invertec = WFS
Trim = 1.00
STT Variables
ADJUST
Adjust Optional
Variables
Save File to Disk
GO FIGURE
GO FIGURE
Download File to Welding
Machine Memory
PROCESS FLOW: REFERENCE
PARAGRAPH:
(SEE APPENDIX B)