Manualshelf

User Instructions

ManualsBrandsLindab Ventilation ManualsElectronicsHighly accurate flow monitor
1234
lindab | we simplify construction
Declaration of incorporation for partly
completed machinery and FCC statement
Ultrasonic device – FTCU
Hereby declares that the partly
completed machinery of the type:
FTCU
are in conformity with the following essential requirements
in Annex 1 of the Machinery directive 2006/42/EC: 1.1.2,
1.1.3, 1.3.4. In addition, the partly completed machinery is
in conformity with all relevant provisions of ordinances in
EMC-Directive 2004/108/EC. The partly complteted
machinery is developed, designed and manufactured with
the essential requirements of the following standards:
EN 61000-6-1:2002 - Part 6-1: Generic standards -
Immunity for residential, commercial and light-industrial
environments
EN 61000-6-2:2005 - Part 6-2: Generic standards -
Immunity for industrial environments
EN 61000-6-3:2002 - Part 6-3: Generic standards -
Emission standard for residential, commercial and light-
industrial environments
EN 61000-6-4:2002 - Part 6-4: Generic standards -
Emission standard for industrial environments
Furthermore, partly completed machinery must not be put
into service until the final machinery into which it is to be
incorporated has been declared in conformity with the
provisions of the Machinery directive 2006/42/EC.
We undertake to transmit, in response to a reasoned
request by the national authorities, relevant information on
the partly completed machinery.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any
interference received, including interference that may
cause undesired operation.
FCC Caution:
Changes or modifications not expressly approved by the
part responsible for compliance could void the user's
authority to operate the equipment.
This equipment complies with FCC exposure limits set forth
for an uncontrolled environment..
FCC Statement:
"This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help."
Signed for and on behalf of the manufacturers by:
Authorised person: Karel Kleinmond
Group Operations Director
2019-01-21 Karlovarska, Czech Republic