Operating Instructions

3
1.4 Intended use
The components of the Linde Fleet Scan may
only be used as intended. The safety
instructions must be observed.
1.4.1 Limited release for use
As of 03.2022, the Linde Fleet Scan is only
approved for use in countries of the European
Economic Area and may only be used in these
countries. The use of the Linde Fleet Scan in
other countries is not authorised by Comnovo.
We will be happy to send you the current EU
declarations of conformity on request.
1.4.2 General
The Linde Fleet Scan is designed to analyse
vehicles at defined locations in industrial
environments.
The components of the system can be used
indoors, mobile or at fixed locations.
If adjustments are made to match local
conditions in the event of radio interference at
the site of operation, re-registration and
approval may be necessary.
1.4.3 Installation
The battery-powered activity trackers can be
attached to the vehicle using a magnet. Make
sure that the activity trackers are fully charged
before installation. Make sure that the activity
trackers are installed in the cabin protected
from environmental influences. They should
not injure anyone, especially the driver, if they
fall.
The gateway and the charging station are
installed in an office for data transmission.
The components supplied must be used.
1.4.4 Limitation for distribution and
permission for operation
Changes or modifications to the equipment not
expressly approved by Linde Material Handling
GmbH or Comnovo GmbH could void the
RED/CE approval to operate this equipment.
Operation on board or in the vicinity of aircraft,
ships or satellites is prohibited, as is use within
a specified distance of a specific radio
astronomical location. In addition, the use of
equipment mounted on outdoor structures (e.g.
a fixed outdoor location), such as the outside of
a building or fixed outdoor infrastructure, is
prohibited. Only portable devices may be used
in mobile scenarios in mixed indoor/outdoor
mode.
FCC and ISED regulatory specification
This equipment has been tested and found to
comply with the limits of a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
There is no guarantee that interference will not
occur in an installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving
antenna
- Increase the separation between the
equipment and receiver
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected
- Consult KION NORTH AMERICA or your
qualified reseller for further assistance
WARNING