Operating Instructions

1 Introduction
14
Operating Instructions - X EN - 01/2020
• Problems could be caused Red/Green
weakness
Risk assessment of driving speed
reduction
In case of entering an signaling zone, the driving
speed reduction for the truck can be activated by the
service technician. This drive speed reduction serves
as a comfort feature for the driver.
The impact of the reduction in the driving speed
on the use of the industrial truck must be
analyzed, evaluated and documented in order to
arrange additional health and safety measures if
necessary. The driver and any people in the area
of operation must not be endangered.
Please note that a speed reduction down to full
stop or 0 mph is prohibited. As a comfort function
it must only reduce the speed of the truck to a
predefined speedlevel, but never 0 mph!
Safety during installation
Installation of LOAS on the industrial truck is
permitted only when the industrial truck is not
moving.
For safety reasons, conversions of or changes to
LOAS are not permitted. Only authorized service
technicians may install, open and connect the
components.
Connections that change the behavior of a third
party system, for example a speed reduction of a
truck or connections to a door-/gate-control-
unit or other third party devices must be done by
certified technicians from the third parties.
The stationary components may be installed,
opened, and connected only when the system is
not connected to the power supply.
Install all devices with the proper covers.
Make sure that seals and screws are properly
seated.
Only qualified electricians are permitted to
install, open and modify Static Units. This
means that authorized service technicians are
usually not allowed to perform electrical
installations on 110 VAC power supplies. This
kind of installations have to be done by quali-
fied licensed electricians.
The equipment have to be checked after these
actions.
Check the local mains voltage before
commissioning. The permissible system voltage
range have to be in line with the local mains
voltage.
id: GUID-73E36D53-02A8-4525-A7AC-2F88BC8C5CE1 - version: 1 - lang: EN - srclang:
Service personnel
Any work to exchange, align and set components of
LOAS and to make adaptations to the industrial
truck must be performed by trained and authorized
service personnel.
The authorized service technician must have
specialist knowledge in the field of industrial trucks.
In addition, they must have specific system
knowledge of the Linde Operator Assistance
System, and the relevant training.
For installing infrastructure nodes, e.g. Static Unit
WARNING
NOTICE
WARNING
WARNING
WARNING
WARNING
WARNING
NOTICE