Dual 2.5“ SATA Mobile RAID User Manual English LINDY No. 20288 For Home and Office Use Tested to Comply with FCC Standards © LINDY ELECTRONICS LIMITED www.LINDY.
English Manual English 2 Device Overview HDD ACTIVE LED POWER LED LOCK HOLE HDD GATE HDD ACTIVE LED USB Host Mode Select switch Mode change switch eSAT A Hardware Installation： 1. Unlock upper and lower covers, covers then open the door. Note: Do not force the door to pen while it is locked, otherwise, you will damaged the lock.
English Manual English 3 2. Place lace one or two hard driver(s) in the slot. Make sure the SATA connector is lined up with the connector inside the Mobile Rack. 3. Carefully push the hard driver into the Mobile Rack,, So that the drive’s drive SATA connector is seated securely, then close the door and lock it. Note: It must be in the lock position when in use. This prevents unexpected removal while working. Note: 1.
English Manual English 4 data security, we highly recommend using Safe configuration (RAID 1 mode). 3. Fast (RAID 0 Mode): The two physical drives are stripped together so that one larger logical volume mounts on the desktop, offering the maximum possible capacity like e in Big mode (the available capacities of each disk are combined) yet y with greater speed than the Big mode (the speed of each disk runs faster to a certain level).
English Manual English 5 continue to repartition and reformat the Mobile Rack hard drive. RAID notification 1. It is better to use the same hard drive brand and memory capacity to use the RAID functions. 2. When using eSATA connector to set JBOD function, if the host cannot support port multiplier function, the computer may not be able to detect 2 hard drives simultaneously.
English Manual 3.Click “Next”, select “I Agree” 4. Select “Just me”, Click “Next” 5. After showing the following Window， Click “Close” to exit.
English Manual 6. Click “Yes” to restart your system. 7.
English Manual English 8 Starting the SteelVine Manager Click Start > Program Files > Silicon Image > 57XX SteelVine >SteelVineManager SteelVineManager. Once started, the SteelVine Manager Application icon can be found in the Notification Tray located at the bottom right hand corner of the screen. Double click the notification tray icon to open the SteelVine Manager GUI status window. The SteelVine Manager icon remains active in the notification tray even if you close the the SteelVine Manager window.
English Manual English 9 Toolbar Buttons on the Status Window RAID function set 1. To access the Basic Configuration Wizard, click on the Configure Box icon along the top of the SteelVine Manager Status Window. 2. To protect against unintended changes, the SteelVine Manager prompts for a password the first time you access the Wizard. Enter the administrator password. The default password is admin. admin 3. appear （ For BIG Mode） 4. The Basic Configuration Wizard dialog will appear.
English Manual English 10 5.
English Manual English 11 6. Open”My Computer” ”Computer management” ”Disk management”. Delete the disk partition of the Mobile Rack. 7. To repartition and reformat the Mobile Rack， then BIG Mode setting OK, that is under work. NOTE： The manner of setting JBOD， SAFE（ RAID1） ， SAFE33， SAFE50， FAST（ RAID0） is the same as the above.
Radio Frequency Energy, Certifications FCC Warning This equipment has been tested and found to comply with the limits for a Class B Digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
