User manual

User Manual English
This will bring up the Telnet interface for the Video Processor. Type ? to list all the available commands,
please refer to the RS-232 & Telnet Commands section of this manual for a description of each
command.
Type IPCONFIG to show the complete IP configuration of the Video Processor. To reset the IP, type
IPMODE to switch between Static IP/DHCP.
Note: All the commands will be not executed unless followed by a carriage return. Commands are case-
insensitive. If the IP is changed then the IP Address required for Telnet access will also need to be
change accordingly. A power cycle is also required for every IP change.
Web GUI Control
On a PC/Laptop that is connected to the same active network as the Video Processor, open a web
browser and type the device’s IP address on the web address entry bar. The browser will display the
device’s Image Adjust, Output Resolution... etc, as shown below. Using this interface you can control the
Video processor in just the same way as with the OSD, RS-232 and Telnet Controls.
Click on the Ethernet tab to reset the IP configuration. The system will ask for a reboot of the device
every time any of the settings are changed. The IP address needed to access the Web GUI control will
also need to be changed accordingly on the web address entry bar.