Safety Instructions

• Use only with the cart stand, tripod, bracket,
or table specified by the manufacturer or
sold with the apparatus. When a cart is
used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
• Unplug the apparatus during lightning storms or when
unused for long periods of time.
• Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as if the power-supply cord
or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally,
or has been dropped.
• The use of apparatus is in tropical and/or moderate
climates.
• TERMINALS marked with this symbol are
HAZARDOUS LIVE and the external wiring
connected to these TERMINALS requires installation by
an INSTRUCTED PERSON or the use of ready-made leads
or cords.
• WARNING: Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type.
• This apparatus shall be connected to a MAINS
socket outlet with a protective earthing
connection.
• WARNING: To prevent injury, this apparatus must be
securely attached to the floor/wall in accordance with
the installation instructions.
• WARNING: Installed (battery pack/batteries) shall not be
exposed to excessive heat, such as sunshine, fire, or the
like.
• Where the mains plug or an appliance coupler is used
as the disconnect device, the disconnect device shall
remain readily operable.
• Where an all-pole mains switch is used as the
disconnect device, the location on the apparatus and the
function of the switch shall be described, and the switch
shall remain readily operable.
• Even when the power switch is in standby status,
electricity is still flowing to the apparatus at minimum
level. When you are not using the apparatus for a long
time, make sure you unplug the power cord from the wall
AC outlet.
• CAUTION: To prevent electric shock hazard, do not
connect to mains power supply while grille is removed.
Disconnect power before fuse replacement.
Replace only with certified/approved fuse of same
type, size, and ratings as marked on product.
For Wireless Products, the Following Statements Apply:
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
WARNING: Changes or modifications not expressly approved
in writing by Line 6 may void the users authority to operate
this equipment.
RF Exposure Statement: This transmitter must not be
co-located or operated in conjunction with any other antenna
or transmitter.
Line 6 Wireless Products operate between 2.400 – 2.484 GHz
and operate at a transmit power of 10mW or less.
A Declaration of Conformity can be found at:
https://line6.com/compliance/
For Products with Lithium Batteries, the Following
Statements Apply:
CAUTION: Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent type.
Batteries shall not be exposed to excessive heat such as
sunshine, fire, or the like.
• NOTE: For the DC-3h, the efficiency at 10% load is
≥ 77.295%
• NOTE: For the Variax Battery Charger Kit, the efficiency at
10% load is ≥ 72.96%
• NOTE: For the DC-DL4, the efficiency at 10% load is
≥ 72.96%