Firmware, Drivers & Software

20
Quick Bypass Assign
There are a few ways to create and edit bypass assignments for any block directly
within the Signal Flow—by using the block’s right-click menu commands, or via the
quick Bypass Assign panel. (The Edit panel’s Bypass/Control screen oers even
more options—please also see page 24.)
Bypass Assignment using the block right-click menu
Right-click on any Preset or Eects block, or directly on the assignment indicator label
above the block, and choose Bypass Assign, where you can select any footswitch or
EXP pedal to create a bypass assignment, change an existing bypass assignment, or
choose the None button to clear the block’s assignment. You’ll also see any existing
assignments within the sub-menu.
Existing bypass and
controller assignments
are shown in brackets
The block right-click Bypass Assign menu
Bypass Assignment using the Bypass Assign panel
Right-click directly on the assignment indicator above a block within the Signal Flow
and the Bypass Assign pop-up panel will appear.
Within this panel, if a bypass assignment already exists for the block, you’ll see
its controller selector highlighted (as shown below). You can simply click on any
footswitch or EXP pedal controller selector to quickly create a bypass assignment,
change an existing bypass assignment, or choose the None button to clear a block’s
assignment.
Left-click on the assignment indicator
Right-click on
the block within
the Signal Flow
Accessing the Bypass Assign panel for a block within the Signal Flow
NOTE: You can create assignments to FS7 or FS8, but you’ll need to have the
device’s Global Settings > EXP2 FS7/8 option (see page 32) set to FS7/8
(as well as one or two external footswitches connected to your device) to be able to
utilize them.
You can also create bypass and controller assignments using the EXP Toe switch
as the footswitch.