Firmware, Drivers & Software

21
Edit/Model Select Panels
The Inspector portion of the Editor toggles to show either the Edit panel, where all
parameters for the currently selected block can be edited, or Model Select panel,
where any available model can be loaded for the currently selected block. At the top
of the Inspector, the Category and Model Name in use by the currently selected
block appears, followed by the Edit/Model Select toggle button. Just click on any of
these items to switch between displaying Edit or Model Select panel.
The Edit/Model Select toggle button
Inspector - Edit panel Inspector - Model Select panel
TIP: Double-click directly on any block within the Signal Flow to display the Edit
panel and the block’s parameters. Us the M shortcut key to display the Model
Select panel.
Editing Model Parameters
When the Edit panel is displayed, simply click on any block within the Signal Flow to
select it to display and tweak its parameters. To follow are a several editing tips (also
see “Keyboard Shortcuts”).
Toggling Block Bypass - A Bypass button is available at the top right of the
Edit panel for any block that oers a bypass option. When bypassed, the category,
model, and all parameters appear dimmed to indicate this state.
Edit panel - block enabled Edit panel - block disabled
Adjusting Parameter Sliders - There are several ways to adjust slider values:
• Click on any slider and drag to the desired value.
• Click on the desired range location within a slider's path and it will jump to the
clicked value.
• While hovering your mouse cursor directly over any slider's path, use your
mouse wheel to adjust it.
• Click the up/down arrow buttons at the right for small, incremental
adjustments. If a down arrow is displayed at the right, click on it to expand its
menu.
• Right-click on any parameter to display the Select a controller panel to create
and edit controller and snapshot assignments (see page 28).
Most parameters are represented by sliders within the Edit panel, however, you’ll
see some models utilize switch type parameters, such as the Speed parameter of
some Modulation models, or the Ratio of most Compressors. All such parameters
can still be adjusted using the same functions, and can have controller and
snapshot assignments created for them.
Switch type parameters within the Edit panel
Type in a Precise Value - Double-click anywhere on a parameter, or on its value,
to manually type in a precise numerical value.
Reset Value - If you're not happy with your parameter adjustment, Cmd+Click
(Mac) or Ctrl+Click (Windows) on the slider/switch to reset it to its initial default
value.
Accessing All Parameters - Note that some model types, such as amps and
complex eects, may have more sliders and controls than you can see all at once
in the Edit panel. You can re-size the application window, or click and drag the
vertical scroll bar at the right to access all parameters (or use your mouse wheel
when hovering your mouse cursor over the scroll bar).
Note Sync - Most modulation and delay eects models oer a Note Sync option,
allowing the modulation rate or delay repeat time to follow the device's main Tap
Tempo value (see “Editing the Tap Tempo” on page 15). For models that oer it,
click the Note Sync button within the Edit panel to toggle the feature on/o. When
active (the Note Sync button is lit), the parameter will change to oer note division
values within its menu, as shown below.
Note value options Note Sync (active)
A Delay block congured for Note Sync