User's Manual

9
Edit View
POD Go has two main views—Play view and Edit view. Edit view is used for creating
and tweaking your tones.
Press VIEW to select Edit view.
Coloredblocksrepresentingamps,cabs,eects,andotheritemsappearontheupper
half of the display, and the selected block's parameters appear on the lower half:
1
16D Pastor of Muppets
[37%]1/16
Delay Transistor Tape
2.948%67%
FeedbackTime Wow/Fluttr Scale Spread
Blocks are objects that represent various elements of your tone, such as amps,
cabs,eects,loopers,inputs,outputs,andimpulseresponses.Theillustrationbelow
explainswhichblocksareavailableatanygiventimeinPODGo.
Selecting Blocks/Adjusting Parameters
1. While in Edit view, turn the Upper Knob to select blocks.
Alternatively, press a Stomp mode footswitch to automatically select the block
assigned to it. The assigned block is bypassed (or if already bypassed, enabled)
and its parameters appear along the bottom of the screen.
2. Press the Upper Knob to toggle the block on and o.
Bypassed blocks appear semi-transparent.
3. Turn Knobs 1-5 below the screen.
Some blocks have more than one page of parameters, in which case dots on the
rightsideoftheinspectorindicatethecurrentpage.Forexample,thedotsbelow
indicate that page 1 parameters are visible (the colored dot) and a total of three
pages of parameters are available:
SHORTCUT: For most time-based parameters such as delay time or
modulation speed, press the knob to toggle between setting the value in ms
or Hz and note divisions (1/4-note, dotted 1/8-note, etc.).
4. Press PAGE or PAGE to access more parameters (if
available).
These blocks are
always in a preset
Add up to 4 additional
eectsblocksanywhere
Distortion
Input Wah Volume FX Loop Amp/Preamp Cab/IR Preset EQ Output
Dynamics EQ Modulation Delay Reverb Pitch/Synth Filter Looper