Product Datasheet/Brochure
Table Of Contents
13
Swapping Footswitches
If you want to change the location of Stomp mode footswitches, you can quickly swap
two footswitches.
IMPORTANT! Swapping footswitch locations does not aect the actual order
of eects. To reorder your eects, see "Moving Blocks in Signal Flow View"
1. Touch any two Stomp mode footswitches until the following
options appear:
Swap footswitches
1 and 2?
OKCANCEL
2. Press the OK switch.
Copying/Pasting an Effect
Eects can be copied and then pasted onto another switch either in the same preset
or an entirely dierent preset.
1. Touch the stomp switch you want to copy and press ACTION.
Action switches appear around the selected eect.
2. Press the COPY BLOCK switch.
3. Touch a switch you wish to paste the block onto—even in a
dierent preset—and press ACTION.
4. Press the PASTE BLOCK switch.
NOTE: There may be situations where a block cannot be pasted into the selected
location. For example, the preset may already include the maximum 9 eects
blocks, or may not have enough DSP horsepower to add another of the specic
model type (see "Dynamic DSP"). In such case, the PASTE BLOCK switch will
be grayed out.
Clearing an Effect
1. Touch the stomp switch you want to clear and press ACTION.
Action switches appear around the selected eect.
2. Press the CLEAR BLOCK switch.
Customizing a Footswitch
If you want to customize the text label displayed on a scribble strip, or change the
footswitch's LED color, follow these steps.
1. Touch the stomp switch you want to customize and press
ACTION.
Action switches appear around the selected eect.
2. Press the CUSTOMIZE switch.
The customize screens appear:
OKCANCEL
Cosmos Echo
Custom Label
Turn Big Knob to
move cursor
Char-
acter
Switch
LED
Auto
C
DELETE
Turn the Big Knob to move the cursor.
Turn Knob 1 (Character) to change the selected character.
SHORTCUT: Press Knob 1 (Character) to cycle through upper case, lower
case, 0, and [SPACE].
Press the DELETE switch to delete the selected character and shift all fol-
lowing characters to the left.
Delete all characters to remove the custom label, after which the footswitch
label displays its normal assignment.
3. Turn Knob 3 (Switch LED) to select the desired color for the
footswitch's LED ring (or turn it o).
Normally, you should leave this set to "Auto."
4. When nished, press the OK switch.