Product Datasheet/Brochure

23
Switch Description
Step on to start recording a loop. Step on to end the loop and
immediately start playback. Step on to overdub additional parts. Step
on again to stop playback.
If you make a mistake on your last overdub, step on UNDO to erase it.
Step on to play the recorded loop once through.
Recording at full speed and then switching to 1/2 speed will also drop
the loop down one octave. Recording at 1/2 speed will double your
looping memory and switching to full speed will cause the loop to play
at double speed (up an octave).
Step on REV/FWD to hear your loop backwards.
NOTE: If you press while loop playback is stopped, this will always record a
new loop, and any previous recording will be discarded.
IMPORTANT! You may change presets while looping, but loop playback will
stop unless the preset you select includes the same type of looper block (mono
or stereo).
2. To return to the previous mode, press MODE (EDIT/EXIT).
Looper Settings
Page Knob
Parameter Description
1
1 Playbk
Adjusts looper playback level. You may nd it useful to
turn this down a bit so your live guitar can be slightly
louder.
2 Ovrdub
Relatively sets the level of your loop while overdubbing.
For example, if your Overdub Level is set to 90%, each
time your loop repeats, its volume will be reduced by
10%, sounding quieter and quieter with each overdub
pass.
3 Low Cut
Filters a portion of the loop's bass and/or treble
frequencies, which can improve the mix with your live
guitar.
2 1 High Cut