Quick Start Manual
Front Panel Controls & ConneCtions
1. Guitar In – Plug your guitar in here.
2. Power Switch – Connect the included power cable to your rear panel.
For optimum tube life always power your amp on with your amp set to
STBY.
3. Standby Switch – Allowtheamptowarmupforoneminutebefore
setting STBY to ON. This extends the life and performance of your
vacuum tubes. It is not necessary to set the amp to STBY before
setting the Power Switch to its OFF position, but it can be a good
habit,ifonlytoensureyou’vegotitsetproperlynexttimeyoupower
up the amp.
4. Master Volume – Setstheoverallvolumeoftheamplierwithout
having to change your individual channel settings.
5. Channel A & B Controls – DRIVE controls how much “dirt” or
“distortion” you get in your sound. BASS, MID, TREBLE and
PRESENCE controls will interact differently depending on which
VOICING you have selected. REVERBadjuststhechannel’sreverb
level, allowing you to switch between channels with different amounts
of reverb.If you don’twant any reverb, simply turn this knob fully