Owner manual

ReaR ConneCtions
1. Cable Retainer - Wrapyourpowersupplycablearoundthisonceor
twice to prevent an accidental disconnect.
2. Power - ConnectyourLine6PowerSupplyheretopowertheunit.
3. MIDI In/Out - Please see www.line6.com/manuals for the skinny on
MIDIfeatures, which allowyou to remotecontrol scene changes,FX
unit memory selection, looper operation, expression pedals, and tap
tempo.PlusdumpandreceivescenedataviaMIDISystemExclusive
messages.
4. Expression Pedal 1 + 2 - Compatible with standard expression pedals,
including the Line6 EX-1. Control FX parameters in real time by
assigning them to either of these expression pedal inputs. The Line6
expressionpedalisapassive10Kohmmonolineartaper pot, using a
standard1/4inchmonoinstrumentcable.
5. Stereo Input - Whenconnectingyourguitarorothermonosourceuse
the
L(MONO) input.
6. Stereo Output - For mono output, use the L(MONO) output.
BasiC opeRation
C
T
Growler
MIX
FILTER
0.84HZ
1A
FREQ
PITCH
Q
1. FX (1,2,3) Units - Youcanrunupto3effectsatonce.EachFXUnithas
2 memories (
A & B),whichcanrunanymodelofanytype(Distortion–
yellow, Delay–green, Modulation–blue, Filter–purple & Reverb–
orange.
2. Memory Footswitches - AllFXUnitshave2memories(A & B). Only
one memory can be active at a time: its footswitch will be brightly lit,
andcoloredtoshowtheeffecttype.Inactiveswitchesaredimlylit.Step
on a footswitch to activate that memory. Step on an active memory
switchtobypasstheFXUnit.
3. Display - Your display will show all the settings for the most recently
selectedFXUnitmemory(showninupperleftcornerofthedisplay).
The display illuminates the color of current effect type (Distortion–
yellow,Delay–green,Modulation–blue,Filter–purple&Reverb–orange).
WhenacurrentlydisplayedFXUnitisturnedoffthedisplaywillshow
therstactiveFXUnitinyoursignalchain.IfnoFXUnitsareonthe
display will read “
All FX Bypassed”.ToeditanactiveFXUnitthat