Owner's Manual

MIDI Mobilizer & MIDI Memo Recorder Advanced Guide Page 7
Software Version
and system Info
List all Memos,
select, reorder,
delete, or create
Length of
Memo
Set name of
Memo, send
via email
Number of MIDI
bytes in Memo
Memo name
Play Memo
Record a
new Memo
Basic
Operation
The picture on the right
shows the main
elements of the MIDI
Memo application. The
blue arrows indicate
information fields and
the red arrows point to
buttons with the text
describing the
functions. More details
of operation are
covered in the
following sections.
Recording MIDI
To enable record mode in MIDI Memo, slide the red slider to the right, across where it says “enable
recording”. The display will change as shown below on the left. To start recording, press the large
round Record button. MIDI Memo will wait until MIDI is received before it actually begins recording, as
shown in the middle display, with the Length counter waiting at 0:00. Once MIDI is being received, all
incoming MIDI information will be recorded. The Size counter will count the number of MIDI bytes
being recorded, and the Length counter will show the amount of time passing while in record, as shown
on the right display.
Each time Record is entered, a new Memo is created. This way, there’s never a chance to accidently
record over an existing Memo. If the current Memo is not blank, then entering record will cause a new
Memo to be created that has the same name but with a new number appended to it.
MIDI Memo will record any MIDI information that it receives, along with the moment in time it is
received. All information from all 16 MIDI channels is captured. Whatever comes in is stored in the
Memo. NOTE: the iPhone will not go into “sleep” mode while recording, to insure no data will be lost.