Owner's Manual

THAT’S USING YOUR FEET: FLOOR BOARD: THE FULL-FEATURED FOOT

7 • 2

TWO MODES

The ﬁrst thing to know is that the Floor Board has two modes of operation:

Channel Select Mode, and Effect On/Off Mode. The Mode Select switch

chooses which mode you’re in.

Mine Looks Funny: Your Floor Board may look a little different than the one illustrated

on the POD manual’s fold out back cover. Older Floor Boards have the label Select

Sound instead of Channel Select. We decided to change the name to Channel Select for

this mode, since that’s, in fact, what you do with it. We changed Sound A, B, C, D to

Channel A, B, C, and D, too. However the Floor Board’s decorated, it works the same.

1. CHANNEL SELECT MODE

Let’s start with Channel Select Mode. Note the line that traces from the Mode

Select switch and points to the two light-up arrows below. The top arrow

lights if you’ve selected Effect On/Off, and the bottom arrow lights if you’ve

chosen Channel Select mode. Give that Mode Select switch a kick if

necessary, and get that lower arrow (Channel Select) lit.

Banks

The two left-most stomp switches on the bottom row ( on your handy back

cover foldout Floor Board diagram) are labeled Bank Down and Bank Up. A

Bank is a section of POD memory that holds four channel settings. The POD has

nine memory banks total. These memory locations come pre-loaded with some

tasty little tones created at Line 6, but you can change them into whatever you

want, and store those changes back into one of the memory locations. You know

which Bank you’ve got because the Floor Board’s display will show you the

same thing as your POD.

The Floor Board notes that you can press the Bank Up & Down buttons at the same

time to switch between Preset and User Banks. This only applies to some of our guitar

ampliﬁer products, not to POD.