Owner's Manual

POD Farm 2 Advanced User Guide – Standalone Operation
6•9
TIP: To feed one single input source (such as your guitar, plugged into your device’s Instrument jack) into
both Tone paths, select “Same as Tone A” in the Tone B Source menu as shown above. This allows you to
use the A/B Switch Box to feed into both Tones (see the following section)!
Tone A & B Input Source Menus
• Each Tone’s Input Source menu allows you to choose which of your Line 6 hardware’s inputs
(Instrument, Mic 1, Line Stereo, etc.) is routed to the respective Tone path. Note that the
options available in the menu differ depending on the connected Line 6 hardware,* and for
Single versus Dual Tone modes.
*Note: When a Line 6 GX, D.I. or GuitarPort is the device in use, no Input Menus are displayed since
these devices offer a single, “fixed” Instrument Input.
• In Single Tone mode, the Tone A Input Source menu lists each of the Mono & Stereo Input
Sources your specic Line 6 device offers.
• In Dual Tone mode, there is an Input Source menu selectable for each Tone within the
Mixer View. The Source menu for Tone A lists each of the Mono inputs your device offers,
The Source menu for Tone B is dynamic and contingent upon the source selected for Tone
A.
The Tone A Input Source menu options with a UX2 device - Single Tone Mode (left) Dual Tone mode (right)
UX1, UX2 & KB37 Users: If you want to Mute only the Main, Analog Outs of your device but still hear
your monitor signal through your Headphones output, use the Mute Main Outs option in the Preferences!
See page 6•5.
A/B Switch Box
The function of the A/B Switch Box is to allow you to route a single input source into either Tone A
or Tone B, or into both. If you have a Dual Tone conguration within POD Farm 2, with a single input
source (or when Tone B’s Input Menu is set to “Same as Tone A”) you’ll see this A/B Switch Box active
in the Mixer. Whenever you have a Single Tone conguration, or have different input sources in Tone
A and B, the A/B Switch Box is disabled.
• Click the A/B button to toggle between feeding your single input source into either Tone A or
Tone B. The A and B lights tell you which Tone is active.
• Click the A+B button to feed your single input source into both Tones A and B simultaneously.
Both A and B lights illuminate to indicate A+B mode is active.
Note that this is a duplicate of the A/B Switch Box you see in the Signal Flow View and functions the
same - we’ve simply added it here as well so that you can easily toggle these Tone A/B options while
making your Mixer adjustments. Wasn’t that thoughtful of us?