Owner's Manual

Appendix B: FBV Foot Controllers
B•15
Looper Mode Footswitch Mappings
When POD HD is placed in Looper Mode, several FBV footswitches change their mappings
to perform the following Looper functions. Please also see “Looper Mode” on page 8•1.
FBV Shortboard - Looper Mode Footswitch Mappings
Footswitch
Label
POD HD Looper
Function
Footswitch LED Description
FX LOOP
Looper Mode On/
Off
Lit when mode
active
Toggles Looper Mode On/Off
STOMP
Undo Lit briefly, while
Undo action
occurs
Erases the most recent recorded
overdub
MODULATION
Play Once Lit while playing
recorded loop
Plays the current recorded Loop
one time only
DELAY
Looper Pre/Post Lit when Looper is
in Post position
Sets the position of the Looper
“Pre” or “Post” in the signal chain
CHANNEL A
Record/Overdub Lit when recording,
Flashes when
overdubbing
Immediately starts recording - Or, if
a loop is currently playing, overdubs
on top of the current loop
CHANNEL B
Play/Stop Lit when playing Toggles the recorded loop to play
and stop
CHANNEL C
Full/Half Speed Lit when half speed Toggles the loop playback and
recording between full and half
speed
CHANNEL D
Reverse/Forward Lit when selected Toggles loop playback and recording
between normal and reverse
Pedal Controllers
FBV Shortboard devices include an “on-board” Pedal, as well as an optional jack on the
back to include a 2nd Expression Pedal. These pedals access the POD HD EXP 1 and EXP
2 assignable controllers. Please see “Expression Pedal Assignment” on page B•16 for how
to assign these controllers to Amp & FX parameters to customize your Presets.
When no additional Pedal is connected to the FBV EXP. PEDAL input, the on-board
Pedal‘s “Toe Switch” will toggle between the control of EXP 1 and EXP 2. The red WAH
and green VOL LEDs on FBV illuminate to indicate the current Pedal Mode, respectively.
(It is also possible to manually assign other functions to the Toe Switch - see “Using the
EXP Pedal Toe Switch” on page B•20.)