Owner's Manual

System Setup
2•2
Page 1, Setup:Utilities Options
The top portion of the screen lists the Flash Memory and USB Firmware versions currently
installed on your POD HD device. The lower portion of the screen offers four options,
adjustable using the Multi-function Knobs 1 - 4.
• Footswitch Mode (Knob 1): This option applies to your POD HD A, B, C & D.*
You’ll see your Performance View screen reflect the functions of these buttons
according to the mode selected here (see “Performance View” on page 1•3). This
setting is global.
• In “ABCD” Mode: The A, B, C & D buttons recall the current Bank’s Presets
A-D.
• In “FS 5-8” Mode: The A, B, C & D buttons toggle the Footswitch 5-8 assigned
Models On/Off.
*Note: This also applies to a connected Line 6 FBV™ Controller’s A, B, C & D footswitches
- please see “Setup Options for FBV” on page B•2.
• Amp Knobs Display (Knob 2): When set to “On,” allows the LCD screen to
momentarily display the actual Amp Tone Knob values whenever adjusting any
physical amp knob. This setting is global.
• Looper FS Display (Knob 3): When Looper Mode is active, this option determines
how and when the Looper screen is displayed (see page 8•1). This setting is global.
• All Views: When Looper Mode is On, the Looper screen is always displayed.
• Performance View: When Looper Mode is On, displays the Looper screen, or the
other Performance View (Signal Flow or Big User) screens, by toggling the VIEW
button. This option can be useful for referencing your Presets or adjusting Models
while Looping.