Owner's Manual

System Setup

2•3

• Trails (Knob 4): When set to “On,” allows the echo repeats and/or decay of Delay

and Reverb FX to continue when the Model is toggled Off. With the Trails option

“Off” the decay is muted instantly when toggling the Model Off. This setting is

saved per Preset. (Note that this feature does not provide a “spillover” of the FX

decay when changing Presets.)

Page 2, Setup:Utilities Options

The options at the bottom of the screen are as follows - all are global settings.

• LCD Contrast (Knob 1): Adjusts the screen’s contrast.

• Tap Tempo LED (Knob 2): Choose “On” to have the LED light for the TAP switch

(or connected FBV TAP footswitch) ﬂash to indicate the current Tap Tempo value.

Choose “Off” to have it remain unlit.

• AC Frequency (Knob 3): All HD Amp Models include simulation of AC hum, typical

of the AC Vacuum Tube Heater component - an important part of the tonality of

a tube ampliﬁer. Set the AC Rate to match that of the USA (60Hz) or UK (50Hz)

frequency for authenticity. (This setting may be subtle depending on the current

Amp Model settings, and may be more apparent when synchronizing this setting

with the AC rate of any tube ampliﬁer that POD HD may be plugged into.)

• FBV Express (Knob 4): This option applies only to a connected Line 6 FBV

Controller. It should only be set to “On” speciﬁcally for a FBV Express MkII model

device. Please see “Setup Options for FBV” on page B•2.