Owner's Manual

System Setup
2•4
Page 3, Setup: Input Options
The Inputs Setup page allows you to select which of the device’s audio inputs are used as
the “source” – sort of like a built-in, programmable patchbay. There is also a control which
adjusts the Guitar input impedance.
• Input 1 and Input 2 Source (Knobs 1 & 2) - Select the physical input(s) that you
want to be the “source” which feeds into the signal path. Note that you can choose
different Sources to independently feed each signal path, or choose Same to feed a
common Source into both paths.
• Guitar In-Z - Select the input impedance of the Guitar input. This feature affects
tone and feel because your guitar pickups are being loaded as they would be by an
effect pedal or a tube amplifier.
Note: The Guitar In-Z setting affects the GUITAR IN input only. Please see the Impedance
Ratings table at the end of this section to reference the input impedance of each individual
model.
• The Auto option dynamically sets the input impedance to match the input
impedance of the very first Amp or FX model in your POD HD signal chain.
• Or, you can manually select from a variety of impedance values from low to high
(22k,32k,70k,90k,136k,230k,1M,or3.5M).Alowervaluewilltypicallyresult
in some high frequency attenuation, lower gain and overall “softer” feel. A higher
value provides full frequency response, higher gain and overall “tighter” feel.
• Inputs Setup -Determines whether theother 3options in thisInputs screenare
applied per Preset, or globally.
• Preset - Recalling a preset will load the Input 1 Source, Input 2 Source and Guitar
In-Z parameter settings as last saved with the individual preset.