Owner's Manual

System Setup
2•8
Knob 1 selects the Output Mode. This is a global setting.
• Studio/Direct: Typically the best option when connecting “Direct” to a mixing
console or recording device. This signal includes “Studio” Cab Models, Mic Model
and an “AIR” convolution to best emulate a mic’ed amp within a room.
• Combo and Stack settings: Optimizes your tone for connecting to an external
amplifier. The signal includes “Live” Cab Models,with no Mic Model or “AIR”
convolution, with a special EQ curve added for each.
• Combo Front & Stack Front: For connecting into the front input of a typical
combo amp or amp head + external cab, respectively. When choosing either of
these Modes, you’ll see these additional options for further tone shaping:
• Lows (Knob 2): Attenuates the low frequencies.
• Focus (Knob 3): Increases the overall midrange.
• Highs (Knob 4): Attenuates the high frequencies.
• Combo Power Amp & Stack Power Amp: For connecting to the power amp of a
combo or head amp.
TIP: When using the Combo or Stack options and connecting into a tube amplifier, we also
recommend that you choose a Preamp Model from the Amp Model menu (rather than one
of the “Full” Amp Models). HD Preamp Models include no power amp emulation, making
them typically better suited for this connection. That said, there is no wrong choice! PODs
have always been about flexibility... Check out all the possibilities and decide which Models
work best for your tone!