Owner's Manual

System Setup

2•9

Page 5, Setup: S/PDIF Output Options

These options are strictly for conﬁguring the signal fed to the S/PDIF OUT.Usethis24-

bit digital connection when connecting to the S/PDIF input of other devices, such as a

computer audio interface or digital mixing console. All settings are global.

Note: When connecting to another digital device, it is best to clock the external device to

follow POD HD (with POD HD as the “master” device) to maintain proper synchronization

- please see your digital device’s documentation for its digital clock features.

• S/PDIF Output (Knob 1): Selects the type of output mode signal.

• Match Outputs: Uses the setting as conﬁgured on the Setup:Outputs screen - see

page 2•8.

• Dry Input: Your Source Input signal with no Amp, Cab, Mic, “E.R.” or FX

processing applied. (Handy for recording a dry signal in your DAW, to which you

can add a Plug-In or “re-amp” later!)

• Sample Rate (Knob 2):Selectsthesamplerate:44.1kHz,48kHz,88.2kHzor96kHz.

When connecting to another device’s S/PDIF input, always be sure to set both units

to utilize the same sample rate.

• S/P Level (Knob 3): Increases the amplitude of the S/PDIF signal: 0 dB.