Owner's Manual

Appendix B: FBV Foot Controllers

B•2

Getting Connected

All FBV devices come with an “RJ-45” cable. Note that this cable is indeed

a standard “Category 5” computer network cable. So, in case you lost yours,

simply run down to any electronics or computer store and ask for a cable of

this type.

With POD HD powered Off, connect this cable between the FBV device’s TO AMP jack

and the POD HD FBV PEDAL jack. If you have an optional Expression Pedal, connect

it to the EXP. PEDAL jack on your FBV now. Then Power On POD HD - You’ll see your

FBV light up, and you’re ready for action!

NOTE: If you have not done so already, it is recommended that you calibrate the Pedal

for your FBV device. Please see the Pilot’s Handbook that came with your FBV device,

or you can download it, or the FBV Advanced Guide, from http://line6.com/support/

manuals/

Setup Options for FBV

There are several Setup options that affect POD HD behaviors when an FBV device is

connected. Hold the VIEW button to enter Setup to access the following options. (Also

see “Accessing System Setup” on page 2•1 for info on other Setup options.)

Setup Page 1

• Footswitch Mode (Knob 1): Conﬁgures the function of your FBV A, B, C & D

footswitches. This setting is global. See “FX & Amp Block FS Assignment” on page

3•7 for info on how to conﬁgure these assignments per Preset.