Owner's Manual
Appendix A: Line 6 Monkey
A•3
As an example, the screenshot on page A•2 shows Monkey has detected that a newer
Firmware - Flash Memory version is available than is currently installed in our device.
In this scenario you can select the Flash Memory item and click Update Selection. Be
sure to read the prompts carefully and Monkey will assist you in performing the update
in minutes. It is especially important not to disturb the devices’ controls and cable
connections until the update fully completes!
Flash Memory Updates and Presets
Flash Memory updates typically include a complete set of Factory Presets, which may
be a revised set that diers from the set of Presets stored in the memory of your
device. You’ll be prompted during the update whether to keep your current Presets.
Selecting “No” will result in your device’s Presets being permanently overwritten.
The prompt during a Flash Memory update to keep your current Presets
TIP! You can save the full set of your device’s Presets as a “Bundle” le to your computer in one
easy step using POD HD Pro X Edit - see “POD HD Pro X Edit Software” on page 1•6.
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
Once a Flash Memory update is complete, it is recommended that you
power on POD HD Pro X while holding down the Nav. Pad - left arrow
button. This performs a “reset” of all global settings to their factory
defaults. This reset also updates your device’s Set List titles with those
included in the new Flash Memory version (if they dier).