Owner's Manual

Appendix B: FBV Foot Controllers
B•23
Indicates no Blocks assigned to the footswitch
Using the EXP Pedal Toe Switch
As noted above, when adding a Wah or Volume/Pan Model to your tone, their Position
parameters are automatically assigned to the EXP 1 and EXP 2 controllers. Most Factory
Presets already include this Wah/Volume switching pre-congured for you. But the
Toe Switch assignment is not set automatically for newly added Amp or FX Models, so
here is how to set this up manually.
• With the Wah Model selected, go to the FS Assign screen and assign its FX Block
to the EXP TOE SWITCH, following the instructions above. This allows the Wah to be
toggled On/O via the pedal Toe Switch.
Assigning an FX Block to the on-board pedal’s “Toe Switch”
Further, if you have a dierent FX parameter (such as the Volume - Position) being
controlled by the opposite EXP Pedal Mode, you’ll likely nd it useful to have the Toe
Switch toggle both these FX Blocks On/O alternately, so that only the desired Model
is active while being controlled. For example, say you have a Preset where the Wah is
controlled by EXP 1, and the Volume by EXP 2:
Note: If you have a “Pedal 2” connected to your FBV (or if using an FBV Longboard) you may
not want to use the following conguration, since the Wah and Volume are already controlled
by your two Pedals individually.