Owner's Manual
System Setup
2•17
Page 9, Setup: L6 LINK Audio
These options congure the POD HD Pro X audio signal fed to up to four Line 6 DT
Series ampliers and/or StageSource™ speakers using the L6 Link connection. The
settings to each of the 4 Amps are saved per Preset. Whenever one or more DT amps/
StageSource speakers are connected to the POD HD Pro X - L6 LINK output, you’ll
see each identied on the screen, such as the “DT50” appears as connected in the #1
Amp position in the above screenshot (note that these are indicators labels only and
not stored per Preset).
1 - 4 Amp Options - Select the specic POD HD audio signal you want fed to each
L6 LINK-connected DT amp/StageSource speaker. Note that the L6 LINK audio signal
fed to each amp is mono.
• Choose Left, Right or Left/Right (summed to mono) to send the main POD
HD output signal.
• Choose the output of one or two specic POD HD Amp Models - Amp Model
A, Amp Model B, or both Amp Model A/B.
• Choose Mute to silence any connected DT amp/StageSource speaker.
This is handy, for example, if you are L6 LINK-connected to both a DT amp
and StageSource speaker.* You can save some POD HD Presets with the
StageSource set to “Mute” to allow an electric guitar tone to be heard through
DT amp only - and other Presets with the DT amp set to “Mute” for an acoustic
tone to be heard from the StageSource speaker only. Even better, if you use a
Line 6 Variax guitar, these electric & acoustic guitar settings can be saved with
your POD HD Preset as well!
*Note: It is necessary to always place the StageSource speaker(s) last in the L6 LINK signal
chain (e.g. - POD HD Pro X > DT50 > StageSource L3). For more about using the L6 LINK
connection, DT Series amps & StageSource speakers, please see the additional documentation
available at http://line6.com/support/manuals/.