Owner's Manual

System Setup
2•18
Page 10, Setup: L6 LINK Control
These options allow you to dictate how up to four connected Line 6 DT Series ampliers
each “follow” the POD HD Pro X Amp Models & settings.* Parameters 1 - 4 correspond
to L6 LINK connected DT ampliers 1 - 4, respectively.
• Each DT amplier can be set independently to follow either the current Preset’s
Amp Model A or Amp Model B.
• The DT amplier automatically congures its power amp Topology settings to
match the selected Amp Model A or B.
• The DT amp controls are also synced to the selected Amp Model A or B.
• Alternatively, you can select a MIDI Channel to set the DT amp’s MIDI
communication channel. This eectively sets the respective DT amp to utilize its
own internal Amp Model (rather than the POD HD Pro X Amp Model), and “syncs”
its front panel controls with other DT Series amps that are set to the same MIDI
Channel.
*Note: These L6 LINK Control settings are for DT Series ampliers only and ignored by any
connected Line 6 StageSource speakers. StageSource speakers do not respond to MIDI CC
messages.