Owner's Manual
Features & Functionality
3•2
• Parameter Value (Knob 4): Adjusts the value for the currently selected parameter.
Each FX Block also oers the following features:
• On/O: Toggle the FX Block “On” or “O” by pressing the ENTER button once.
When O, your signal ows through the FX Block unprocessed.
• Move FX Position: Each FX Block can be moved throughout the signal chain,
providing complete routing exibility. Place any FX Model before the Amp (“Pre”),
after the Amp (“Post”), or within one of the parallel Paths A & B - see “Amp Model
Positioning” on page 6•1 for details.
• Saved Per Preset: All FX Block positions, their loaded FX Models and all FX
parameter values within the tone are saved with each Preset.
FX Loop
For any one of the 8 FX Blocks, you can load the FX Loop rather than an FX Model.
This allows you to position the POD HD Pro X hardware FX Loop anywhere you like
within the current signal path - even within one of the parallel Paths A or B!
The Signal Flow View with the FX Loop selected
Note that it is necessary to set one of the FX Blocks within your Preset to the “FX Loop” before
you’ll hear the signal fed through your SEND & RETURN device connections.
Access options for the FX Loop at the bottom of the Signal Flow View, or in the Edit
Mode screen. You can also toggle the FX Loop “On” or “O” by pressing the ENTER
button once. The FX Loop’s position and all its parameter values are saved per Preset.
Please also see “FX Loop” on page 5•4.