Owner's Manual

Features & Functionality
3•4
• Volume A (Knob 1): Controls the volume level of the Path A output. 0 dB is unity
gain.
• Volume B (Knob 2): Controls the volume level of the Path B output. 0 dB is unity
gain.
• Pan A (Knob 3): Adjusts the left/right stereo balance of the Path A output.
• Pan B (Knob 4): Adjusts the left/right stereo balance of the Path B output.
Moving FX Blocks
Any of the 8 FX Blocks can be moved throughout your tone’s signal ow, providing
tremendous routing exibility. To move any FX Block, start within the Signal Flow View
and select the FX Block to be moved. Press the MOVE button and you’ll see the selected
FX Block appear “raised” to indicate it is now moveable.
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
Pressing the Move button to reposition an FX Block
The FX Block can now be moved as follows:
• Use the Nav. Pad buttons to move the FX Block to the desired position.
• Move the FX Block into either Path A or B, and place it before or after an Amp
Model within the path. Use the Nav. Pad buttons to move the FX Block to
the opposite path. This allows you to run your eect in “parallel” and blend the
individual Path A & B outputs using the Mixer’s Level & Pan options!
• Once the FX Block is in the desired position, press the MOVE button again to drop
it into place.
• Amp Blocks can be moved into xed positions within the Pre or Post signal path
areas, or within the Paths A & B - see “Amp Model Positioning” on page 6•1.
• The Looper can also be selected and moved either to the start (“Pre”) or end
(“Post”) of the signal ow - see “Looper Mode” on page 8•1.