Owner's Manual

Amp, Cab & Mic Models
6•7
Whenever you adjust any of the Amp Tone knobs, you’ll see the “Momentary” AMP:
EDIT LCD screen temporarily displayed, showing the actual values of the Tone knobs
for both current Amp A & Amp B Models (depending on your Amp Knobs Display
setting, see “Page 1, Setup:Utilities Options” on page 2•2). Also see the next section
for more about the AMP: EDIT options.
Amp & Cab Edit Display
Double-press the ENTER button to access the Amp & Cab Edit screens. You’ll see up
to 5 pages of options here, allowing you to ne-tune Amp, Cab and Mic settings.* All
settings in these screens are saved per Preset.
*Note: When the selected Amp Model is a “full” Amp Model, you will see ve Amp Edit pages,
with pages 2 & 3 offering additional “deep-editing” power amp-related functions, and pages 4
& 5 offering deep-edit Cab functions, as described below. When the selected Amp Model is a
Preamp, you will see only three Amp Edit pages, which offer the same options as the Amp/Cab
Edit pages 1, 4 and 5 described below. Use the Nav. Disc left & right arrow buttons to access
all available pages.
Amp Edit - Page 1
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
Page 1 of the Amp:Edit Screen - both Amps are On
• With both Amp Models On: You’ll see the screen’s respective controls
update as you adjust the Amp Tone knobs, as shown above. Note that the
black “dots” around each knob indicate its last-saved value. You can also
still access the Amp, Cab & Mic Model and Amp A/B selections via the Multi-
function Knobs 1-4 while this screen is displayed.