Owner's Manual
Amp, Cab & Mic Models
6•11
Amp Edit - Page 5
Here you’ll nd even further “deep-editing” parameters for the Speaker Cab, allowing
you to surgically rene the the feel and frequency response to your personal taste.
• Knob 1: Adjusts the overall level of the modeled speaker Resonance, which
results in a more “lively,” brighter response on higher settings. Increasing the
Resonance Level will cause the overall volume to increase as well.
• Knob 2: Adjusts the low frequency level of the modeled speaker resonance.
Just as the name implies, increasing the value on this knob adds more low
end “Thump” to the Cab tone.
• Knob 3: Adjusts the Decay time of the modeled speaker resonance. This
control provides the feel of a “tighter” speaker cone at lower values and a
“looser” speaker at higher values.
Note: The above three Cab parameters are interactive - As the Resonance Level is decreased
so are the effects of the Thump and Decay parameters. Thump and Decay are applied to the
modeled speaker resonance, therefore, if the Resonance Level is set to a minimum, the effects
of Thump and Decay parameters will not be audible.
Resonance Level, Thump, and Decay controls will only be audible when the POD is in Studio/
Direct output mode.