Owner's Manual

FX Models
7•4
Modulation Models - Parameter Reference Table
Model Parameters
80A Flanger Speed Range Enhance Manual Even Odd
Frequency Shifter Freq Mode -- -- Mix
Ring Modulator Speed Depth Shape AM/FM Mix
Rotary Drum Speed Depth Tone Drive Mix
Rotary Drm/Hrn Speed Depth Horn Dep Drive Mix
Common Parameters
The following parameters are common to most Modulation FX Models.
• Speed: Adjusts the modulation/oscillation/tremolo speed for the eect, with
higher settings providing faster rates. Note that the Speed can be adjusted
to a Hz value or Note Division:
• Choosing a Hz value provides a specic modulation speed in cycles per
second.
• Choosing a Note Division value provides a time that is based on the current
Tap Tempo (see “Tap Tempo” on page 1•5).
• Depth: Adjusts the intensity of the modulation. Higher settings result in more
extreme pitch bending, wobble or throb, depending on the eect.
• Fdbk (Feedback): The amount of delayed signal that is fed back into the
eect. Higher settings can provide more dramatic textures.
• Mix: Sets the balance of the “Dry” and “Wet” signals. At 0% no eect is
added to your signal; at 100% you will hear the eected signal only. For
Chorus, Flanger & Phase FX, results are typically best with the Mix set
between 0 to 50%. For Vibrato, Tremolo and Rotary FX, try the Mix at 90 -
100%. Feel free to experiment!
Note that the Script Phase, Pattern Tremolo , AC Flanger & 80a Flanger do not offer a Mix
parameter. Their dry/wet balance is “xed” just like the classic pedals that inspired them!