Owner's Manual
Using the Looper
8•5
• Playback (Knob 1) - Use Multi-function Knob 1 to adjust the Looper
playback volume. You may nd it useful to turn this down a bit so that your
live guitar can be slightly louder.
• Overdub (Knob 2) - Use Multi-function Knob 2 to determine the volume of
your loop in Overdub mode. For example, if your Overdub Level is set to
90%, each time your loop begins a new overdub its volume will be reduced
by 10%, sounding quieter and quieter with each overdub pass.
• Hi Cut (Knob 3) & Lo Cut (Knob 4) - Use Multi-function Knobs 3 & 4 to adjust
these EQ options, to reduce the treble and bass of your Loop playback. It
can be helpful to reduce these to optimize the “mix” of your Loop playback
with your live guitar. These controls reduce the High and Low frequencies
more as you raise their values.
1/2 Speed Operation
The Looper utilizes both the 1/2 Speed and Full Speed options for recording and
playback. These options directly aect the maximum Loop recording time.
POD HD Looper Record Time
Full Speed 24 Seconds maximum
1/2 Speed 48 Seconds maximum
Specic behaviors apply, as follows:
• Full Speed: When set to Full Speed before recording, the Looper provides
up to 24 seconds max. recording time.
• Playback of the recorded Loop at the Full Speed setting is heard just as
recorded.
• If you change the setting to 1/2 Speed, your recorded Loop is played back at
half speed, as well as pitched one octave lower.
• 1/2 Speed: When set to 1/2 Speed before recording, the Looper provides
up to 48 seconds maximum recording time.
• Playback of the recorded Loop at the 1/2 Speed setting is heard just as
recorded.
• If you change the setting to Full Speed, your recorded Loop is played back at
double speed, as well as pitched one octave higher.