Owner's Manual

Edit Mode
4•5
• Pre - Positions the Volume effect before the Amp model (and before all other “Pre”
designated FX) within the signal ow.
• Post - Positions the Volume effect after the Amp model (and before all other “Post”
designated FX) within the signal ow.
Minimum & Maximum
These two parameters allow you to configure the Volume level for the “heel” and “toe”
positions of the Volume pedal, respectively. Adjust these as desired if you want something
other than the normal behavior. For example, set Min to 100% and Max to 0% if you want
to “reverse” the Volume pedal action!
FX Loop Menu (POD HD400 Only)
The FX Loop SEND and RETURN jacks on the back of POD HD400 allow you to patch
in your favorite external pedals or rack FX.
The FX Loop SEND & RETURN jacks
Use the only L/MONO jacks if connecting your external FX in a mono connection, or use
the pairs of connections if your FX are in a stereo or mono-stereo configuration. The FX
LOOP LEVEL switch should be used to optimize the level for your external FX; Use LINE
for rack FX or STOMP for pedals.
Once you have FX connected to the FX Loop, you can utilize the Edit Mode - FX Loop
options for specific behaviors with your current tone. These settings are saved per Preset.