Owner's Manual

Amp, Cab & Mic Models
5•3
Amp Model Type
As the default setting for all Amp Models, this option is set to “Full” to provide the
complete sonic characteristics of the classic amp’s preamp + power amp stages. However,
you can alternatively select “Preamp” to obtain just the preamp stage of the amp.
It is recommended to select the Preamp option when feeding your output to an external
tube amp, such as if connecting from the UNBALANCED OUTPUTS into a guitar amp,
or when using the L6 LINK™ connection with a Line 6 DT50™ or DT25™ amplifier.
That said, there is no wrong choice. PODs have always been about flexibility... Check out
all the possibilities and decide which Models work best for your tone!
Note that, when either the Full or Preamp option is selected, the additional application of Cab
and Mic models is dependent upon the device’s OUTPUT MODE settings and the particular
output jacks you are using. Please see “Output Mode Options” on page 2•5.
Cab Model Selection
When selecting a new Amp Model, the Amp automatically loads a default, matched
speaker cabinet model (see “Cab Models” on page 5•10). But you can use the CabMdl
option to choose any of the 16 available Cabs for any Amp Model. Your Cab Model
selection is retained with each individual saved Preset.:
Mic Model Selection
When selecting a new Amp model, a default Mic model is automatically loaded along
with it. But you can use the MicMdl option to choose a different Mic for any Amp Model.
Your Mic Model selection is retained with each individual saved Preset.