Owner's Manual
Amp, Cab & Mic Models
5•7
Manual Mode
As described earlier, selecting a new Amp Model loads the new Amp, along with default
settings for each of the Amp Tone knob, Reverb knob and Amp Edit Mode parameters. If
you prefer to NOT have these settings change when selecting a new Amp Model, use the
Manual Mode:
Press and Hold the FX ONLY
button to toggle in and out of
Manual Mode
When in Manual Mode, the following behaviors apply:
• The amber LED Bank/Patch display shows “- - -” to indicate you are in Manual
Mode.
• The positions of the 5 physical Amp Tone knobs & Reverb knob always reect the
values in use - what you see on the physical knobs is what you get.
• Selecting a new Amp Model does NOT load the Amp’s “default” settings for these 6
knobs. Instead, all 6 knobs’ settings remain as-is, unless you turn the knobs.
• Likewise, all “Deep Edit Parameter” values within the Amp Edit Mode (see previous
section) remain at their current settings when changing Amp Models.
• Selecting any Preset will automatically exit Manual Mode and load the new Preset,
including its last-saved Amp Model and parameter settings.
FX Only Mode
Use the “FX Only” mode if you prefer to keep the Amp, Cab & Mic models’ processing
bypassed, such as to use only the unit’s FX if running POD HD into a guitar amp. The
following behaviors apply for the FX Only mode:
• To toggle FX Only mode on/off, simply toggle the FX ONLY button, which remains
lit when this mode is active.