Owner's Manual

Features & Functionality

3•13

Using the EXP Pedal Toe Switch

As noted in “Expression Pedal & Variax® Knob Controller Assignment” on page 3•7,

when adding a Wah or Volume/Pan Model to your tone, their Position parameters are

automatically assigned to the EXP 1 and EXP 2 Pedal Modes. Most Factory Presets already

include this Wah/Volume switching pre-congured for you. But the Toe Switch assignment

is not set automatically for newly added FX Models, so here is how to set this up manually.

• With the Wah Model selected, go to the FS Assign screen and assign its FX Block to

the EXP TOE SWITCH, following the instructions above. This allows the Wah to

be toggled On/Off via the pedal Toe Switch.

Assigning an FX Block to the on-board pedal’s “Toe Switch”

Further, if you have a different FX parameter (such as the Volume - Position) being

controlled by the opposite EXP Pedal Mode, you’ll likely nd it useful to have the Toe

Switch toggle both the FX On/Off alternately, so that only the desired Model is active

while being controlled. For example, say you have a Preset where the Wah is controlled by

EXP 1, and the Volume by EXP 2:

Note: If you have an additional Pedal connected to PEDAL 2, you may not want to use

the following conﬁguration, since the Wah and Volume are already controlled by the two

Pedals individually.

• Click the EXP TOE SWITCH switch so that the red EXP 1 LED is lit.