Owner's Manual

Amp, Cab & Mic Models
6•7
Editing Amp Parameters
To toggle the selected Amp model On or Off
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
Press the ENTER - AMP ON/OFF button once. Toggling the Amp “Off” results
in bypassing the Amp, Cab and Mic processing.
To adjust the Amp Tone
Turn any of the Amp Tone knobs to adjust the desired settings for the selected Amp.
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
SAVE
HOLD FOR SYSTEM & I/O
VIEW
P
R
E
S
E
T
S
The Amp Tone knobs
Whenever you adjust any of the Amp Tone knobs, you’ll see the “Momentary” AMP EDIT
LCD screen temporarily displayed, showing the actual values of the Tone knobs for both
current Amp A & Amp B Models (depending on your Amp Knobs Display setting, see
“Page 1, Setup:Utilities Options” on page 2•2). Also see the next section for more about
the AMP: EDIT options.
Amp & Cab Edit Display
Double-press the ENTER button to access the Amp & Cab Edit screens. You’ll see up to 5
pages of options here, allowing you to ne-tune Amp, Cab and Mic settings.* All settings
in these screens are saved per Preset.
*Note: When the selected Amp Model is a “full” Amp Model, you will see five Amp Edit
pages, with pages 2 & 3 offering additional “deep-editing” power amp-related functions,
and pages 4 & 5 offering deep-edit Cab functions, as described below. When the selected
Amp Model is a Preamp, you will see only three Amp Edit pages, which offer the same
options as the Amp/Cab Edit pages 1, 4 and 5 described below. Use the Nav. Disc left &
right arrow buttons to access all available pages.