Quick Start Manual

Editing Amp, Cab & Mic Parameters
When an Amp Block is selected, you can use the Multi-functionknobs
1-4toselectAmp,Cabinet,orMicModels.Whenusingadualampsetup,
Knob 4 allows you to assign which amp gets controlled by the
DRIVE,
VOLUME, and TONE knobs.
Amp Block OFF
A
B
Turn any of the Amp Tone knobs to adjust the desired settings for the
selectedAmp.
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
SAVE
HOLD FOR SYSTEM & I/O
VIEW
P
R
E
S
E
T
S
Whenever you adjust any of the Amp Tone knobs, you’ll see the
“Momentary”
AMP: EDIT LCDscreentemporarilydisplayed,showingthe
actualvaluesoftheToneknobsforbothcurrentAmpA&AmpBModels.
Or, to manually display the
AMP:EDIT screens, double-press the ENTER
buttonwhenanAmpModelisselected.You’llseethescreen’srespective
controls adjust as you adjust the
DRIVE, VOLUME, and TONE knobs. The
black“dots”aroundeachknobindicateitslast-savedvalue.WithanAmp
Blockoffyou’llseeonlyaVOLknob.Thisisaseparateparameterstrictly
for the Amp Model’s Bypass Volume. Use the
VOLUME knob on your
device to adjust this, and its value is stored separately with the Preset for
whenevertheAmpBlockisBypassed.
YoucanusetheAmpModeldeep editparameterstocompletelychange
the behavior of any amp model from subtle to extreme. It's like having
your very own amp techinician by your side. From page 1 of the
AMP:EDIT
screen, press the
4 Way Nav Pad right arrow button to view page 2.
Knob 1 - MASTERsetstheamountofpowerampdistortion.Thisparam-
eter is highly interactive with all deep edit parameters.
Knob 2 - Setsthe
amountofSAGinthepoweramp.Athighersettingsthemodelbecomes
"squishy" with more touch sensitivity and improved sustain.
Knob 3 -
ControlshowmuchheaterhumandACrippleinteractswithyourtone.
Atmaximumsettingthingsgetreallyfreaky-you'vebeenwarned.
Knob
4 - SetstheMulti-Function knobstoalterthesettingsonthispageforAmp
AorAmpB.
Press the 4 Way Nav Padrightarrowbuttonagaintoviewpage3.Knob
1 - Adjuststhebiasofthepowertubes.Atmaximumtheampisoperat-
ingin ClassA. Settominimumyougetavery"cold"ClassABbiasing.
Knob 2 - BiasExcursionisaphenomenonthatoccursonlyasthepower
tubesarepushed.Setlowforatighterfeel.Sethighformoretubecompres-
sion (
Note: Turn DRIVE&MASTERuptoexperiencethisphenomenon).
Knob 4 - SetstheMulti-Function knobs to alter the settings on this page for
AmpAorAmpB.
Press the 4 Way Nav Padrightarrowbuttononemoretimetoviewpage4.
Knob 1 - Setstheamountof"earlyreections."Highersettingsaddmorere-
flective room sound to your tone.
Knob 2 - TurntochangeCabinetModels.
Knob 3 - SelectsMicrophonetype.Knob 4 - SetstheMulti-Function knobs